• Benchtop 300 ml Cartridge Pusher

  • Product code: 98022
  • Material and equipment:
    Manufacturer:
  • The 98022 Benchtop 300 ml Cartridge Pusher is a designed for dispensing low viscosity product to high extrusion rate pastes. The cartridge pusher mechanically applies pressure to the cartridge plunger using a pneumatically driven ram. The pressure to the ram is set with the 0-60 psi pressure regulator. The regulator pressure should not be used above 50 psi, as the maximum cartridge rating is 60 psi and the ratio on the plunger is 1.1.

    Since there is not high pressure air over the cartridge plunger, there is no opportunity for air ingress into the cartridge. The cartridge cylinder and ram are machined to tight tolerances to minimize the potential for skewing the cartridge plunger. A grease reservoir is included which continually applies a thin film of grease to the plunger shaft. If the cartridge cylinder was contaminated, this would prevent the shaft from being jammed (bonded).

    The cartridge cylinder can be removed for easy maintenance. The ram is brought to the home position for loading and unloading using the switch adjacent to the regulator. There is a low level sensor that is compatible with the Loctite Digital Dispense Controller (item # 97101), or the Loctite Digital Multi-Function Controller (item # 1022006). A valve such as the Poppet Valve (item # 986300) will be required with this unit.

  • Price: Contact
  • Data Sheet User Manual Operational Video Integration with Robot 3D Stp File 2D Dwg File 2D Dxf File

    Spare Parts:

    Item Title
    982644 Fischbach Cartridge Adapter, 1/4 x 18 NPT thread to cartridge end
    984826 Replacement Sleeve Kit
    984832 Fitting Kit, 1/4 inch NPT x 1/4 inch tubing. 10 pack

     

Rating: 
 
 
 
 
 
 0point0turn
Sale quantity 0 chiếc

The 98022 Benchtop 300 ml Cartridge Pusher is a designed for dispensing low viscosity product to high extrusion rate pastes. The cartridge pusher mechanically applies pressure to the cartridge plunger using a pneumatically driven ram. The pressure to the ram is set with the 0-60 psi pressure regulator. The regulator pressure should not be used above 50 psi, as the maximum cartridge rating is 60 psi and the ratio on the plunger is 1.1.

Since there is not high pressure air over the cartridge plunger, there is no opportunity for air ingress into the cartridge. The cartridge cylinder and ram are machined to tight tolerances to minimize the potential for skewing the cartridge plunger. A grease reservoir is included which continually applies a thin film of grease to the plunger shaft. If the cartridge cylinder was contaminated, this would prevent the shaft from being jammed (bonded).

The cartridge cylinder can be removed for easy maintenance. The ram is brought to the home position for loading and unloading using the switch adjacent to the regulator. There is a low level sensor that is compatible with the Loctite Digital Dispense Controller (item # 97101), or the Loctite Digital Multi-Function Controller (item # 1022006). A valve such as the Poppet Valve (item # 986300) will be required with this unit.

 
 

Category product


Cart

Support online

Engineering Department
Business Divisions
Mr Quan
+84964507345

Counter

  •   Online 5
 
  •   Today 1,774
  •   This month 19,414
  •   Total 967,175
  • Loctite®
  • Henkel
  • Fisnar
  • Humiseal
  • Dymax
  • Multicore